by Denkstrom
All storiesSolar desalination without toxic brine: breakthrough from Rochester

Solar desalination without toxic brine: breakthrough from Rochester

Laser-structured metal surfaces enable solar desalination without toxic wastewater: researchers at the University of Rochester developed a process where seawater salt crystallizes as solid instead of being discharged as brine into the sea. Valuable lithium can be separated as a byproduct.

Desalination plants produce hundreds of millions of cubic meters of drinking water daily worldwide, yet for every liter of fresh water produced, typically one and a half to two liters of toxic brine form, harming marine ecosystems. Researchers at the University of Rochester developed a process that sets this waste balance to zero: solar energy desalts seawater without liquid residues, salt falls out as solid and can be collected. The study appeared in the journal Light: Science and Applications.

Why brine is the real problem

Around 2.2 billion people lacked access to safe drinking water in 2022, according to the joint report from WHO and UNICEF. In water-poor coastal areas, seawater desalination is seen as a logical solution. The global main process is reverse osmosis: seawater is forced under high pressure through a semipermeable membrane, typically with 3 to 10 kilowatt-hours of energy needed per cubic meter of fresh water. The byproduct is highly concentrated brine, often twice the original seawater salt concentration.

This brine is predominantly discharged directly back into the sea. The consequences are measurable: elevated salt concentration kills benthic organisms, lowers oxygen content on the seafloor, and stresses coral reefs near discharge points. For inland regions that want to use salt water aquifers or brackish water, the disposal problem is even more acute because no sea is available for discharge.

What Rochester developed and how the physics works

Research director Professor Chunlei Guo from the Laboratory for Laser Energetics at the University of Rochester used femtosecond laser pulses to structure metal surfaces at the nanoscale. The resulting microstructures give the metal two properties simultaneously: near-complete light absorption (the surface appears deep black) and superwicking, the ability to pull and distribute liquid through capillary action with extraordinary force.

The panel is divided into two zones. In the active zone, a thin water film is drawn over the hot surface, evaporated by absorbed solar energy, and condenses on a cooler surface as fresh water. The passive outer zone works on the principle of the coffee stain effect: when water dries at one point, capillary action pulls dissolved particles to the periphery. Dissolved salts migrate to the passive zone and crystallize out instead of accumulating in the active zone and clogging the surface. The result: neither brine nor chemical pretreatment. The salt is present as solid and can be removed and collected.

Guo and his team showed in laboratory trials that the process can additionally selectively extract lithium and other valuable minerals from the brine. Since lithium is needed for batteries and global demand grows, the salt itself could have economic value that helps finance the operating costs of the plant.

How other approaches have dealt with the brine problem so far

The clogging and brine problem has been known in desalination research for decades. Multiple approaches were pursued without solving the fundamental problem.

Conventional solar distillation is as old as humanity: film or glass over saltwater, evaporation by sun heat, condensate drips into a collection vessel. The method actually produces no saltwater waste but delivers only a few liters daily per square meter and clogs quickly from salt deposits. The Rochester method breaks through this exact clogging mechanism via the coffee stain principle in the passive zone.

Lenan Zhang from the Massachusetts Institute of Technology published a method in 2021 in Energy & Environmental Science using floating solar absorbers on saltwater that employ passive salt distribution. The system achieved higher volumes than conventional solar distillation but still produced brine. According to research by the University of Rochester, the Rochester method is the first laboratory proof of zero liquid waste solar desalination documented in a peer-review journal.

Commercial zero liquid discharge systems (ZLD) already exist, such as in industrial desalination in Saudi Arabia. They use combined membrane and thermal crystallization techniques and are significantly more expensive than standard reverse osmosis. The Rochester approach works purely solar-thermally without external energy.

Three conditions must be met before the approach leaves the lab

Scalability from laboratory panel to field installation: The demonstration works in the range of a few square decimeters. Larger panels must work in wind, changing solar radiation, and changing salinity. According to the University of Rochester, Guo has filed patents for modular designs. Details on prototypes outside the lab are not published.

Long-term stability of the laser surface: Whether the femtosecond laser structure retains its superwicking properties after months of seawater use or is altered by corrosion or salt deposits is not investigated in the publication. RO membranes must be replaced every 3 to 5 years. An analogous lifespan issue for the structured metal panels would be economically decisive.

Volume efficiency compared to conventional solar distillation: The crucial comparison is not with reverse osmosis (which uses external energy) but with existing solar distillation at equal area and equal solar radiation. A quantified efficiency figure is not provided in the publication. Chunlei Guo's group has researched laser-induced metal structures for hydrophobic and hydrophilic surfaces and anti-ice coatings for years. The desalination application is a direct advancement of this basic research toward applied technology. The team announces next steps without a timeframe.