The best of the laboratory cells tested retained 90 percent of its initial efficiency after 1,000 hours of accelerated aging at 65 degrees Celsius and achieved a power density of 36.2 milliwatts per square centimeter under rear illumination corresponding to an albedo of 0.20. According to the report, this test is an accelerated, controlled laboratory experiment and does not demonstrate decades of outdoor durability.
Tandem cells place a perovskite absorber on top of a silicon cell to make use of a larger part of the solar spectrum; the degradation of perovskite materials by light, heat and outdoor conditions has so far been considered an obstacle to their widespread use. Bifacial variants also use some of the light scattered and reflected by the ground, known as albedo, which is captured at their rear, a feature that could improve stability and energy yield, according to a perspective article in Joule published in 2022 by Michele De Bastiani and colleagues. To achieve the necessary current matching between the perovskite cell and the silicon cell in bifacial monolithic tandem cells, the authors recommended a low-bromide perovskite with a narrow bandgap that suppresses halide segregation and significantly improves stability. From model calculations, the authors of the study published on October 29 derive a ranking of the lattice deformability of the four perovskite compositions examined, which agrees with their temperature-dependent X-ray diffraction measurements.
An approach KAUST outlined in 2020
The current study selected perovskites with a bandgap near 1.55 electron volts and a lower bromide requirement to reduce degradation caused by halide segregation under illumination. Researchers from KAUST in Saudi Arabia and institutions in China and Turkey were among those who worked on the project. As early as September 15, 2020, Professor Stefaan De Wolf of KAUST reported that perovskites with a lower bandgap were known to be significantly more stable. According to the Perovskite-Info report, the 2020 outdoor test of the KAUST tandem cells was the first outdoor trial of such cells in Saudi Arabia and confirmed the performance improvement.
Comparing different approaches to greater stability
In September 2026, a team led by Nanjing University reported a certified, stabilized efficiency of 30.77 percent for a different tandem cell, as well as nearly unchanged performance of an encapsulated cell over 3,400 hours, according to a pv magazine report. The team used a different method: a treatment with methylammonium thiocyanate that improves crystal growth on industrial textured silicon.
What the new study does not yet show
According to L’EnerGeek, an independent technical analysis published on the day the study was published points to unanswered questions about the transition from laboratory cells to industrial modules: large-area stability, thermal cycles, humidity and manufacturing stresses still need to be tested. During peer review, a reviewer criticized the original manuscript, saying that although the data were high quality, there was a gap between the proposed mechanisms and the stability tests selected; the reviewer initially did not recommend the paper for publication. The authors subsequently added temperature cycling tests on single-junction solar cells from room temperature to 65 degrees Celsius over 1,000 cycles, as well as the outdoor trial at KAUST, in which the more stable composition retained 89 percent of its initial efficiency outdoors, while a comparison composition retained 79 percent. The researchers declare in the publication that there are no conflicts of interest; the report reviewed does not say who funded the work. The material descriptor proposed by the authors must also be confirmed using other formulations and by other laboratories, the report notes.
The next step: Long-term testing of industrial modules
The report identifies long-term testing of industrially manufactured modules under real-world conditions as the next decisive step. According to the report, the study does not specify a commercialization date, industrial manufacturing costs or an annual yield gain for an installation in France.
